New to Lakka OS/Linus. Install completed, but won;t boot

[Pup]

Hello all

I am attempting to install Lakka to my Asus eeePC 1015 netbook. I followed the startup steps; created the UBS drive and installed to it, but the first boot loops infinitely. It shows the Lakka flower for a few seconds, then the screen goes completely black/off, then goes back to the flower. Searching the forum has some threads stating to do some commands of various types, but I never get any command line to type anything.

Thank you all

[Smileyman2004]

Have you tried turning it off and on again

[Pup]

Have you tried turning it off and on again

snark aside, of course

[metchebe]

You should be able to access the command line as this post indicates:

Lakka - How to access command line

Try this on an installed system: Boot with CAPS LOCK on (this enables the SYSLINUX prompt) At the prompt: SYSLINUX 6.04 EDD 6.04-pre1 Copyright (C) 1994-2015 H. Peter Anvin et al boot: linux tty Wait for boot and then CTRL-ALT-F3 The above worked for me for Lakka 2.1 i386 in Virtualbox. The key is step 1, it may vary on different hardware.

[Pup]

Try this on an installed system: Boot with CAPS LOCK on (this enables the SYSLINUX prompt) At the prompt: SYSLINUX 6.04 EDD 6.04-pre1 Copyright © 1994-2015 H. Peter Anvin et al boot: linux tty Wait for boot and then CTRL-ALT-F3 The above worked for me for Lakka 2.1 i386 in Virtualbox. The key is step 1, it may vary on different hardware.

I have a Lakka command line Though now, the screen keeps cycling between on and off, oddly, but it’s working at least.

More to come

[Pup]

Try this on an installed system: Boot with CAPS LOCK on (this enables the SYSLINUX prompt) At the prompt: SYSLINUX 6.04 EDD 6.04-pre1 Copyright © 1994-2015 H. Peter Anvin et al boot: linux tty Wait for boot and then CTRL-ALT-F3 The above worked for me for Lakka 2.1 i386 in Virtualbox. The key is step 1, it may vary on different hardware.

the ‘live ssh’ command doesn’t work, it only states 'Live: not found" :\

[gouchi]

the ‘live ssh’ command doesn’t work, it only states 'Live: not found" :\

Because you installed it already

Try to boot with ssh textmode or ssh tty retroarch=0 then try to edit your configuration file with menu_shader_pipeline = "0"

Thank you.

Source

[Pup]

Because you installed it already

Try to boot with ssh textmode or ssh tty retroarch=0 then try to edit your configuration file with menu_shader_pipeline = "0"

Thank you.

Source

progress! ssh textmode didn’t work, but ssh tty retroarch=0 stabilized the screen… but the config file doesn’t have the menu shader pipeline line so I added it. I am in Lakka OS

More to come!!

thank you sir/ma’am!