I installed the stable lakka for the UDOO and i have a black screen on boot, i have tried flashing with Linux and win32disk . I’ve tried all the nightly builds as well as stable, tried 3 different tv’s but I’m not having any luck at all.
Is there anything i can try to make it work?
Just tested it again , still comes up with black screen and then no signal, I’ve tried ssh but the board is not working at all with this installed.
I have tried several SD cards and SD card readers to flash the image.
I’m no noob to single board computers , Linux , Retro arch.
I make Tutorials on many Linux based single board computers , Google/You tube ETAPRIME
so what i did was install a build of Ubuntu mate for the UDOO quad and loaded retro arch within in, most emulators run well considering the UDOOs hardware.
Thanks for the help.
Ok I will test it again on my UDOO when I come back home.
What I can tell is that the release on the website have been tested manually by myself and works. (With SD card)
Thank you. How are you flashing this image? Are you changing any settings within the uEnv.txt file?
So this is where it hangs, i’m using putty to see the startup process.
U-Boot SPL 2013.10-rc4 (May 22 2016 - 22:26:47) Boot Device: microSD card
U-Boot 2013.10-rc4 (May 22 2016 - 22:26:47)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR Board: Udoo Quad DRAM: 1 GiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment
auto-detected panel HDMI Display: HDMI (1024x768) In: serial Out: serial Err: serial Net: using phy at 6 FEC [PRIME] Warning: failed to set MAC address
Hit any key to stop autoboot: 0 mmc0 is current device SD/MMC found on device 0 653 bytes read in 11 ms (57.6 KiB/s) Importing environment from mmc (uEnv.txt)… Checking if uenvcmd is set … Running default loadimage … 5656792 bytes read in 263 ms (20.5 MiB/s) 32922 bytes read in 17 ms (1.8 MiB/s) Booting from mmc … Kernel image @ 0x12000000 [ 0x000000 - 0x5650d8 ]
Booting using the fdt blob at 0x18000000 Using Device Tree in place at 18000000, end 1800b099
Starting kernel …
It’s very strange…
I tested the last release on my UDOO Quad without changing anything in the uEnv.txt and it was working fine…
I guess you already tried to use another SD card?
I really don’t get what is causing this bug.